SO--after finishing my first lamp re-do (and loving the results), I have had my eye on this beige beauty on my hubby's side of the bed.  It is the only beige thing in our all white bedroom. 
I just started at the seam and rolled the shade along the paper--marking both the top and bottom edges until I got to the seam again.  Then I connected the edges--this gave me my basic shade shape.  I then added about 3/4 of an inch to both sides so I would have enough to roll over the inside edge.
Then I used the pattern I just created and cut it out of my fabric.  I used SPRAY ADHESIVE and sprayed the wrong side of my fabric.  
Next I started at the seam and matched up my top and bottom to where I wanted it to lay (so that I would have equal amounts on both edges to fold over to make a nice finished edge).  I worked my way around the shade, pressing the fabric smooth all the way around.  When I got to where I started--I folded over the edge so it looks nice and then I used a little fabric glue and glued it all the way down the seam.  
Then I was ready to tackle the ends.  I just ran a bead of fabric glue all the way around the edge of the shade and just a touch on the inside edge of the shade.  Then I folded the fabric up and over the edge.
I also used a pin to tuck in the fabric right to the edge of the shade. This gives a really finished edge.
And this is my finished project. I have to admit that it is not my favorite. I just don't care for the lamp in general--but I think this re-purposing makeover saved its life for a couple more years till I decide to replace it. I definitely am glad to see the beige gone!!
And I did it all for free since I already had all the materials on hand!  So that's not bad!
 
 


 
 
 
 
 
 
 



















No comments:
Post a Comment
Thank you for your comments!